Send connection requests safely

You will have the extension sending connection requests from your own Chrome, one at a time, inside your limits.

Before you start

• The extension installed and signed in: Install the Chrome extension.
• Your limits saved: Set your LinkedIn pace (limits and hours). If they go above the ceiling the app will not make a campaign active.
• A campaign with people and a sequence: Build a LinkedIn campaign.

Approve the notes

1. Open the campaign, then Review notes. A note is in one state: No draft yet, Drafted, Approved or Rejected.
2. Read the draft, pick another of the drafts if you like, and edit it. A note is up to 300 characters, and every bracket must be filled in because it is sent exactly as written.
3. Press Approve, then confirm. There is no approve-all.

Approving only saves your approval. It sends nothing.

Start the run

1. On Campaigns, make the campaign Active with its switch. This marks it only.
2. Open the extension panel and go to Today. Under Campaigns on the Adapt Leads website, press Show my campaigns, then Add to my campaign on yours.
3. Under What Start does choose Connect. (Warm up only visits profiles and sends nothing.)
4. Press Start sending requests.

What you will see

Doing now shows who it is on, and the state reads Running. It keeps going while Chrome is open, and you can close the panel. To stop, press Pause for now. It also stops by itself on a LinkedIn warning: LinkedIn showed a warning.

The footer shows invites used against your cap of 80 in seven days. Once sent, a request cannot be taken back. LinkedIn does not allow automated activity and your account carries the risk: read LinkedIn risks and honest limits.

More: Run a LinkedIn campaign.